Airsoft G36 to M4 Magazine Adapter

thingiverse

UPDATE: 2 more designs. These are flat-bottom for easier prints overall. Also adjusted the TM design nozzle slightly. Left the old designs up just in case ;) There are two designs: 1.) The JG/TM design which has its own feeding tube as part of the hopup chamber. This one I have personally tested on my own G36. Depending on your version you may need to shave off part of the alignment tube on top. This is normal. For some reason JG and TM don't have a standardized length of hopup feeding tube between versions. 2.) The Umarex g36/sl9 version, which needs the additional feeding tube distance. This one I have not personally tested. But if you have and want to give feedback I would love to hear it Use the same mag latch printed for either type. You will need 1x m3x25 bolt 1x m3 nut 2x m3 Washers (to prevent wear on the plastic sections) 1x 3 or 4mm diameter spring, 8-12mm based on the strength you want. Airsoft m4 mags are NOT to exacting specs, so you may experience feeding issues if the magazine doesn't latch vertically and snugly. To alleviate this, tape the back of your mags (or the inside of the mag well) until theyre snug. Design is free, but please don't commercialize it without permission. If you want a print of this I sell them. Contact me at mdigibou@yahoo.com Tips are also appreciated :) paypal.me/mdigibou