Airsoft P90 Front Handgard

thingiverse

I really like the front handguard in cod mw for the p90 so i made this. This is a Front Handguard design ONLY for airsoft use so that you can remove the upper receiver freely with it on. Uses M-lok accessory or rails and comes in two versions. The barrel washer is there for those who do not have the threaded washer thing that is usually threaded on the front. Its also used to hold the adapter on snug with a extended outer barrel or mock suppressor. The thin shroud has enough space for basic barrel extensions or the use of the ps90 extended barrel with the m-lok stuff on. If you do use the ps90 extended barrel with the barrel washer you will need to use a barrel extension as the thread on the ps90 outer barrel does not start at the base of the outer barrel and will not thread on good so there's a chance to damage your threads. You will need a 7 inch barrel extension for the thin shroud should you go with this. The other one labeled SV will fit mock suppressors up to 38mm diameter (39mm max). The lower wall prevents it from rotating when installed. The mounting block goes into the upper receivers slots located near the font. One for the cybergun upper, will also fit tm p90 tr spec. The unknown block was because I got a boneyard metal tri-rail upper receiver and the size did not match with cybergun's or tm's spec. I'm not sure what brand it is so its set to unknown. For the blocks just mirror it for both sides. After installing it on you might find that is hard to fit it on but don't worry, simply push the lower part of the adapter into the slot and push it up towards the receiver to fit it in. After that screw in the bolts and you done.this can be done with the extended barrel on. To remove it simply remove the bolts and push forwards and downwards carefully till it comes off. Same as above for removal but I had a 35mm od mock suppressor so any larger you probably have to take it off first. Hardware: 12 M4 screws/bolts 12 M4 nuts