Airsoft P90 Hop-up hard + tracer

thingiverse

Hello everyone!!! I present to your attention a custom hop-up based on the original, in this version of a reinforced body, and a hole has been added for installing a UV diode for tracer balls. It was printed and corrected many times, and this was the last version of this hop-up. THIS IS A COMPLETE PARTS KIT - body 3 options -clip -wheel -hand -pin - a device for sharpening diodes not inside the case It is recommended to use transparent PETG for manufacturing. 5 mm UV LEDs are used. Post-treatment: sandpaper, dremel, and dichloroethane for return after printing PETG plasticity 11.04.2022 UPDATE 1. Fixed some design flaws 2. added a large number of options for clips for the shift barrel, depending on the elastic you use. 3. added 3 options for shifting the axis of the barrel, for a non-standard cylinder head. (If someone has more accurate measurements, I will be glad to hear) 4 resin printing gives incredible accuracy, printed, pasted, earned. When printing FMD printers, some work may be required. P.S. It is planned to make a trigger for the sensor module, so that the backlight is produced only at the moment of bringing the finger to the trigger.