Airsoft Trip Mine

cults3d

This is a trip mine designed for Airsoft use. Everything you will need is 3D printed except for the spring that will go below the plunder and the pin to keep it held down. The spring can be found here: https://www.amazon.com/dp/B076LN7CHH?psc=1&ref=ppx_yo2ov_dt_b_product_details Cut down the sping to 65mm. As for the pin, any piece of small metal should work. A paper clip, or what I used is this: https://www.racedayquads.com/products/steel-z-bend-1-2mm-push-rod-2-pack-choose-your-length The trip mine cover exit is set at about a 45-degree angle with almost a 180-degree spread. The ground stake should provide enough stability to keep the mine held in an upright position. I recommend only loading about 100 bbs or less, you don't want too many that they don't all get pushed out, or too little that you don't hit your target. I would advise fishing line would be best to use for the wire. Print everything in PLA, I used 15% infill but you can use more for added strength.