[Airsoft] WE G36 IDZ stock adjustment latch

thingiverse

Repair part for the positional adjustment latch on the WE G36 IDZ stock, the retainer pin is very fragile so if yours has broken, you can print this part to repair it. A 3.2mm steel rod is required cut down to 11.15mm. (I have no idea why it's 3.2 but that's what WE uses by default, I suspect 3mm will work too), heat the rod a little bit with a lighter and then glue it in place. Make sure the printed orientation is as shown in the image above for maximum strength, I used PLA x PHA for extra toughness as the brittleness of PLA might not bode well for the stress the retainer pin is put under.