Alfa Romeo 159 Sunglasses Holder Latch

prusaprinters

<p>This is a latch (circled in red on the second photo) for the sunglasses holder on the Alfa Romeo 159.</p> <p>It just clips into place. To get the old one out insert something fairly flat in next to it down to where you can see the bit of round clip/pivot point and then twist until it pops out.</p> <p>Mine broke at the tip and I could not find the piece that broke off so I did not have the exact measurements, but through few iterations I think it fits fairly well. The replacement seems to work better than the original one which would sometimes get stuck.</p> <h3>Print instructions</h3><p><strong>Printer Brand:</strong> Prusa<br/> <strong>Printer:</strong> <a href="http://amzn.to/2DxjZlB">i3 MK2S</a><br/> <strong>Rafts:</strong> No<br/> <strong>Supports:</strong> Yes<br/> <strong>Resolution:</strong> 0.2<br/> <strong>Infill:</strong> 100%</p> <p><strong>Notes:</strong></p> <p>Print with ABS or similar, due to high temperatures that can develop in a car during summer. I printed the replacement with nylon.</p> <p>Supports are needed due to protrusions on both sides of the latch.</p>