Alignment Guide for a Feather Edge Fence (or a Close Board Fence)

prusaprinters

<p>This is a simple alignment guide to help you build a Feather Edge (aka Close Board) fence using boards 125mm wide. I catches on the pervious board and gives you a 25mm overlap. Also, the front edge of the build is where to put the nail to hit the narrow end of the board beneath.</p> <p>Simple design but was very useful when I did my fence this weekend!</p> <h3>Print instructions</h3><p>Not particularly fussy. I printed it at 0.3mm 15% infill in Prusament PETG since I thought it might survive better if I missed the nail with the hammer! However, it will be fine in PLA as well. Orange was to stop it getting lost in the grass.</p>