Alignment Jigs For Zone Mortalis

thingiverse

Eberleg's zone mortalis tiles are amazing, but keeping the wall sections aligned during assembly if your not printing the whole thing in one go, can be tricky. This is a jig I made for keeping the corner and long wall sections aligned properly when glueing. The straight section jig was the only one that took time to make, the corner sections just use a simple right angle. I included it anyway. The tolerances on the straight wall jig were probably WAY to tight because after the slight shrinkage of PLA I had to do light sanding so it would actually fit over the tile parts lol. It might be wise to scale the part up slightly in your slicer if you want to avoid this finishing step.