Aluminatus Corner Clamps With Height Adjuster & Glass Clamps

thingiverse

This is a new version of the bed corner plates and also clamps to actually hold the glass down. The works in conjuction with my center support if you need to pull a bow out of the glass, but it also helps keep the glass and spreader down if you have a flat glass. Since the heat spreader and glass are stacked on the corners they may want to move a little or not land in the exact same height when taken off and reinstalled. This pulls them down and holds them better. These bed corners use the same side pieces as the other bed corners (F-300 and A-300). The side pieces that move (A-300) are just barely snugged just to hold the glass in perfect place. These are not intended to actually clamp the glass in tension. The new hold down clamps take care of that. See: https://www.thingiverse.com/thing:101807 https://www.thingiverse.com/thing:2740345 These use the same hardware except there is an added M5 for the corner clamps. This gets snugged so there is just a little resistance. You can spin them out of the way to remove the glass. You can also move the adjusters up and down with the clamps in place. They should spring enough to allow precise adjustment of the corner heights. I print them in ABS. I used .2mm layer and 20-30% infill. The screws that go into plastic only should thread themselves with just a little pressure and provide enough resistance to stay put when adjusted.