AM8 2020 3D Printer Electronics Case for MKS GEN 1.4 w/ MOSFET

thingiverse

This design is an enclosure for the MKS Gen 1.4 line of boards. It features space for a MOSFET, 2 40mm fans, one 60mm fan, and wire management. On top of that, the air ventilation slots on the bottom allow the mainboard to be cooled from both sides since the MKS Gen features a MOSFET that cools through the board rather than using a standing heat sink. I haven't printed the full design yet so I would appreciate it if you report issues with the design. I recommend the following fan guards for use with fans: https://www.thingiverse.com/thing:340131 https://www.thingiverse.com/thing:2949626 It is possible to use other boards in this design. This is because the you make your own mounting holes with the use of a drill and several M3 nuts and bolts. You essentially put a nut on both sides, where the bolt sticks out of the case and inside the case. I did this design as there are several MKS Gen 1.4 boards that have different mounting configurations and alignments. UPDATE 2: The new V3 models are much more improved. These updated files include a strengthened lid, M3 mounting holes for the MKS Gen 1.4 and MOSFET, and inside fan guards to protect power cables. UPDATE: There is now a second version that includes both a 229mm and 218mm length versions. This allows for people with 220x220mm beds to print this model. While the big version is much more "spacious", it requires a bigger build volume. The smaller version is, well, smaller. However, it is harder to do cable management and the fans have to be mounted to the outside.