AM8 CHANGES

thingiverse

The P-Initiator greatly enhances homing precision, outperforming those low-quality Chinese mechanical switches. A small metal bracket is attached under the X-Carriage Mount using a strong adhesive. Three high-intensity G4 flat LEDs, powered by 12-volt DC at 2 watts each, are installed on top of the chassis to illuminate the heatbed. For optimal performance, print them using ABS or PET-G filaments because these LEDs can get extremely hot. To ensure user safety, please install a fuse in the LED switchbox. This precautionary measure will prevent any potential electrical hazards. Additional upgrades include: A cable management system is achieved by installing a cable duct between the power adapter and electronic board, making it much easier to organize cables. The metal frame of your AM8 printer must be grounded for safety reasons. To address this issue, I mounted the power adapter on an aluminum board that is connected to the chassis. If not done properly, there is a risk of electrical shock or even electrocution. Sensor Details: Heatbed Position Sensor from Banggood Voltage: DC 6-36 volts Sensor Dimensions: 2.2 x 1.7 x 1.7 cm