AM8 Z Motor Mount and Top Mounts with Bearings On Both Ends!

cults3d

I am starting to get close to completely redesigning the AM8 now. This is a set of upper and lower Z mounts for the AM8. It uses the stock rods, screws, steppers and couplers but mounts them in super sturdy holders with bearings at both ends. This uses the 608RS type skate bearings. Optionally you can use 8mm locking collars and included spacers to lock the shaft at the top bearing. Print with support as they lay. The Z rods are held captive. Install the Z Lead Screws and Couplers on motors then insert into motor mounts and attach. Upper parts slide down over the rods. There's upper bearing retention caps and rod retention caps meant to use M3 self threading or really any M3 screw to attach. I use M5 x 10 screws and T nuts for my AM8 so these will fit that for sure. #Thank you!