Amiga 1200 micro SD card reader bracket

thingiverse

I was looking for a solution allowing me to access micro SD card without opening my Amiga 1200. I wanted to keep in invisible at the sametime. I came out with a design of a reader bracket that can be mounted in the extpansion bay at the back of the Amiga. Micro SD card is easilly accessible after opening the small lid at the back. Printed with PET-G without any supports. You have to use 2.5 mm drill bit to drill a hole at the bottom. It's just 0.4 mm thick and keeping this hole plugged allows for a good quality printout without the supports. There are 2 versions - with either square or rounded side screw posts. Holes are design to use 3mm screws. Files are also available on GitHub: https://github.com/maniana-net/3D-Prints/tree/master/Amiga%201200%20microSD%20reader%20bracket