Amiga PicoPSU Remix

prusaprinters

<p>This is a remix of the Amiga PicoPSU Case by Lemaru. The cable I have had no strain-relief on it, so this has a cable clamp built in. I also moved the 12V input to the same side as the switch. There is also a hole for another socket for 5V output. I needed some power to run the LCD monitor I am going to be using, so decided to use this PSU's output to run it. For those who don't need it there is a blanking plug to close it off.</p> <p><em>UPDATE 29/10/2019</em><br/> New top piece which can take a small voltmeter. I set mine to monitor the 5V rail as I think that is the more important one for the Amiga. Can't remember exactly which volt meter I had (brought ages ago) but should be similar to these: <a href="https://www.banggood.com/Geekcreit-0_28-Inch-2_5V-30V-Mini-Digital-Volt-Meter-Voltage-Tester-Two-Line-Voltmeter-p-974258.html?rmmds=search&amp;ID=228&amp;cur_warehouse=UK">https://www.banggood.com/Geekcreit-0\_28-Inch-2\_5V-30V-Mini-Digital-Volt-Meter-Voltage-Tester-Two-Line-Voltmeter-p-974258.html?rmmds=search&amp;ID=228&amp;cur\_warehouse=UK</a></p> <p>The LEDs shine through the plastic (which is about 0.6mm thick) and when switched off there is no evidence that it is there. One side note, the holes for the display don't line up, I secured mine with hot glue.</p> <h3>Print instructions</h3><h3>Category: Computer Print Settings</h3> <p><strong>Printer Brand:</strong> Prusa</p> <p><strong>Printer:</strong> I3 MK3S</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0.2</p> <p><strong>Infill:</strong> 20</p>