Ammo Can Rifle/Shotgun Rest

thingiverse

This is a rifle/shotgun support I designed to clip onto an ammo can. It gives you a handy platform to rest your gun on if you are shooting in the field or on the range. I recommend installing some door seal tape or felt in the inside of the rest where the gun will sit in order to give a tighter fit and of course to avoid scratching your gun. I also recommend printing a minimum of 4 exterior walls to give the support the rigidity it needs to withstand shotgun/rifle recoil. I have used it exclusively with a 12 ga shotgun with 2-3/4" slugs and it has held up without issue. I'm not sure if this will fit "standard" ammo cans if there is such a thing but it will fit the harborfreight ammo dry box linked below. https://www.harborfreight.com/ammo-dry-box-61451.html It prints in a single piece and should break free and rotate in the X/Y plane after some force is applied to turn it and break any connections the printer accidentally made. I have posted this to Thingiverse because an employee at Vance Outdoors in Columbus, OH saw this design and asked if I would post it.