Among Us Travel Chess Set

prusaprinters

<p>Made a couple of years ago, this model was printed using filament changes on a Prusa Mini+. &nbsp;The hats were printed in different colours and glued to the pieces, as was the the pawn “bone” piece. &nbsp;</p><p>Board is modelled from scratch - use the included filament change on early layer to get the different coloured checkerboard. &nbsp;The entire set was scaled and built to fit into the folding travel sized base which closes with a couple of magnets and uses filament/wire as the hinge material.</p><p>Figurines on bases - use the included filament change to get a base of a different colour from your figure, and print two copies of it in your desired crewmate colours.</p><p>Bone and guts uses a filament change to get ooey gooey guts over the blood red base. &nbsp;Very happy with how those turned out.</p><p>Hats are quick to print, but i tended to print multiples and pick the “best” ones. &nbsp;They're prone to detaching because of the tiny contact area with the bed, but since they're such a tiny and quick print you can normally get a few good ones or just run another batch :)</p><p>Visors are printed in bulk in a contrasting colour and glued.</p><p>Figurine is a modified version (remix) of <a href="https://www.printables.com/model/42250-among-us-dead-or-alive-improved,">https://www.printables.com/model/42250-among-us-dead-or-alive-improved,</a> thank you to Shawn for that model. &nbsp;License follows the CC BY,NC,SA of that model.</p>