Amphibious Char - Submarine Tank

cults3d

Inspired by an old 1946 Jo and Zette comic book, the "Manitoba" no longer responds, here is the amphibious tank that allows Jo Zette and Jocko to escape from the underwater site of the mad scientist. Before going any further, I advise you to look at the "exploded" image of the object, this allows you to understand the assembly. Just a decorative object, for good results, after printing I spray a Grey primer, then sand, and the same repeated operation to obtain the desired finish. Then a layer of MARLY CATERPILLAR colour (Aerosol). Allow to dry well. Cutting the windows in a piece of transparent plastic and gluing them with model or wood glue (no cyanoacrylate) Paint accessories (if used) and tracks (GUNZE) Glue the accessories together, the turret can be screwed in (rotation) Assemble the whole by gluing (custom I put two pieces of 2.5mm² copper in the 2 holes on the face to match the front body from the back, by pressing the 2 tracks the assembly holds well) For the barrel (radius) ,a piece of ALU tube or other is glued in the hole of the turret (part impossible to print) At the assembly the tracks have assembly clearance, it is wanted, after the primer and painting the clearance disappears. The version in the photo has undergone corrections (wider strapping of the body to resemble the original), the Front Lamp has been drilled to be replaced by a half Yellow bead and an aluminium chip, the installation of a yellow LED is possible. The rear body has a separate door for easier printing (glued door or small hinge) I left the rear body with integrated door for the pressed ones Parts 6 to 12 are not necessary, it is the interior equipment...... (¯'-.¸(¯'-.¸(¯```-.¸ SlotEd ¸.-'´¯)¸.-'´.-'´¯)¸.-'´¯)