Anachrony Insert

thingiverse

The goal here was to make an insert that fits on the Ender3 or smaller, and would fit the original KS and the Fractures of Time expansion (which isn't out yet). So no guarantee it will fit the expansion until its out. but it should hold most of it and hopefully either small reprints or some extras in a bag. I had to make a couple of compromises. - the miniature storage isn't great when the box is on its side, if your minis are painted that would be an issue but otherwise its minor. - does NOT fit sleeved cards, I needed every mm there just wasn't room - The player board where you place you leader is not included in the player boxes, so they go on top of the insert with the other card board. I need to put the player boxes on their sides and that board is taller than the box. You will need to print 1 of each file except the player Box, you need to print 5 of those, there is a separate lid file for each faction. The ExoSuitBig files will fit 5 sets of exosuits. These should be the four originals and the new path of unity. The Guardians file will store the 6 exosuits from the Guardians expansions. Its import that this set goes in this file as those are the smallest miniatures and the only ones that will fit here. I left room for the following from fractures of time 5X of each building (so 20 more buildings) 10x more super projects Flux resources 2 sets of large cards There is space for one more container that is about 20-30MM high and about 80x80mm wide. this should be enough for the new collapse tiles and misc other things, I didn't make any space for any of the solo components Personally I'll put them in the expansion box and put it in the basement. Also with all the new boards it might not all fit box with the lid being higher. Ieft 20-30 mm above the insert for the boards not sure if it will be enough but it should be close. Likely with the expansion the lid will sit high with the expansion boards If you print and use this insert please take a pic and post a make here, it what i enjoy by making the designs. The card holders where not designed for card sleeves. If someone really wants them and can give me the outside dimensions for each card I can see about adjusting those components. But probably wouldn't work for the leaders as the player boxes don't have any extra space.