[ANET A2] Fan Duct

thingiverse

This is designed to work with my Fan Holder print, I'd reccomend you use that with this (Since it's specially designed for 50 mm x 50 mm x 15 mm fan designs, and my fan mount works with that size of a fan.) print. I'll upload a better design later, but for now, this is the best I can do. Thanks. Print Settings Printer: Anet A2 Rafts: Yes Supports: Yes Resolution: 0.2 Infill: 100% Notes: I'd reccomend printing in this orientation. (Not shown: Make sure your supports are set to "Everywhere" if you're using Cura.) Post-Printing Remove filament with a pair of flush trimmers and some pliers. Worked fine for me. How I Designed This I measured distances from my fan opening to my hotend, and modelled the actual fan opening to create a good snug fit. It was a really good learning experience, because I'm really new to solidworks.