Anet A6 Duct + V2 - Anet A6 ventillation

thingiverse

aration_a6.stl (accent issue when upload :-) ) Is an adaptation from one planned for A8. Very large to the point of not being able to see the beginnings of printing to make sure everything goes well. Another thing, I use clamps to hold a boroscilate glass and this piece took up so much space that the clamps were ejected when impressions on the edges a6_fan_duct_v2_with_support.stl (better name no? :-) ) All the problems noted above are corrected with a somewhat revised ventilation so that the direction of the holes for the air flow arrives just below the nozzle. Definitely not perfect yet but I am satisfied with the result. I add support because Slic3r is unable to make support only with buildplate. If you use Cura select "Touching buildplate" a6_fan_duct_v3_with_support and gap.stl It's the same than V2 with gap Print Settings Printer Brand: RepRap Printer: Anet A6 Rafts: Doesn't Matter Supports: No Resolution: 0.2 Infill: 15% Notes: For Cura use "Touching buildplate" For slicer without functionnality ==> No support