Anet A6 Front Frame Y-Axis Reinforced

thingiverse

Remixed. Added Brace structure to prevent bending and punched holes to reduced amount of material required. A LOT stiffer than fragile and brittle Anet original front Y axis frame. Because the original design was made to print flat on the bed, it warps easily due to uneven cooling of outer edges. Also warps when printed upright. This vertical print layout features two little feet to enable 2 mm of support, which will allow cooling of initial layers. After wasting so much filament on warped prints, this gave best results for highest print reliability.Just make sure Z-axis has braces to reduce wobble.