Anet A6 Power Cover with Outlet

thingiverse

****UPDATE 25May2019**** I realized the the size of the uploaded relay carrier was incorrect. Please use the "Relay Carrier_Size Update" file instead. I have also added a cover for the relay carrier hole in case you do not have a relay board to use (Use "Relay Cover 0.375") ************************************ This is a power cover for the Anet A6, that also has a power outlet in the back. I was sick of having to plug in the raspberry pi 3 that I am using to run octoprint and Klipper into another outlet. I decided to do something about it, and created this cover. The outlet box should house any square outlet, but it is specifically desigend for the one I am using. I don't have a part number, but it is form Lowe's and has one outlet and 2 USB outlets. It is also designed to fit the screws that come when you buy the outlet, but you can buy any 6-32 x 3/4 screws, and they should fit just fine. The switch is the typical switch used as an Anet upgrade. The holes in the cover for the switch should fit an m4 screw. You may have to try fairly hard to get it to start, but after that you should be good to go. The relay board that I am using is a Velleman 4-relay board. You can pick one up off Amazon or any hobby shop. The holder for the relay board just snaps into the cover, but you will need 4 screws to hold the board to the holder. 6-32 x 3/8 screws fit perfectly.