Anet A6 spool holder

thingiverse

Spool holder that goes between LCD and frame instead of white spacers. Print Settings Printer: Anet A6 Rafts: Doesn't Matter Supports: Yes Resolution: 0,3mm Infill: 20% Notes: I made 2% oversize to accommodate ABS shrinkage, but it came out little to big and fit quite tight on the screws, so I think there is no need for that. I also used brims for print. The print was wade on kapton tape with ABS, The print peeled of the tape of the bed little bit just at the end of the print, but it came out really nice. I would also recommend to turn off combing (in cura: Expert config - Retraction - Enable combing). With combing it pushes of the filament out of extruder on the path to the holes and the holes are printed pretty bad. The spool cylinder was 0,8mm side shell, 0,9mm top/bottom shell and 10% infill.