ANET A8 120V Power Cable Wire Clamp for stress relief

thingiverse

The photo shows a wire clamp to hold and provide stress relief for the 120V power cord to the Anet A8 power supply. The clamp is quick to build and requires no other hardware since it uses existing screws on the printer. The clamp is mounted to two Z motor housing bolts next to the power supply. The part uses all the remaining screw length beyond the nuts and is thin, about 1.6 mm. Disassemble one screw at a time after securing the nut. Using a piece of tape, secure the nut's position in the motor housing by applying tape to it and pressing firmly on the tape to hold the nut in position, then unscrew the first screw. Align the clamp and insert the first screw and reassemble. Then move the cable into position, it will snap firmly into the clamp opening. Make sure to have slack on the cable from the clamp to the power supply. Screw in the second bolt. Done!