Anet A8 Dual Mosfet, RPi, 4 Channel Relay, & Motherboard Case with Reset Button

thingiverse

I extended the original design by designzuk to include mounts for a raspberry pi and 3 channel relay. The quality of the modifications are not on par with the original. However, it worked well enough for my needs so I thought it might be useful for anyone with a similar setup. A few notes: * Only the usb and ethernet port are exposed for the pi. * I am powering the pi through the GPIO pins. If you want to use the micro usb power input you will probably need a 90 degree usb cable or adapter as space between the pi and the mainboard is somewhat limited. * This sticks out quite a bit from the back of the printer, so it might not be a good option if space is an issue.