Anet a8 e3dv6 carriage with cover

cults3d

Hi this is a project for anet a8 e3dv6 carriage with full cover https://youtu.be/MUoVLFd7to4https://youtu.be/tAb1GjBGXTEhttps://youtu.be/HKWUBR_bv6k It it a complete carriage solution with base plate, e3dv6 mount, fun ducts and cover with fans. It can be used with standard lm8uu bearing blocks or with my bearing block solution from my other project that i highly recommend. It was tested, fits and works well. two fans one for nozzle radiator and second for print coolling adjustable ,removable and replaceable fan ducts all cables can be fit inside, so it looks clean has hole for cable and bowden covering elastic pipe easy cover removal for maintenance can be used with standard bearing blocks, but recomend mine solution (much much better) You need: - print all parts - two 40mm fans - e3dV6 (maby other fits? i do not know) - bearings with blocks - some m3 screws, and nuts different length - some m4 screws and nuts to bearing block mount to the plate - a little soldering skills? (have to replace or extend funs cables) Note: please take care about mounting plate scews. There are lots of them in main plate, and some of them are covered by parts mounting later, so before mounting the parts look to place m3 nuts in holes before covering them, becouse there will be no access to them later!!!. #define X_MIN_POS -15 #define Y_MIN_POS -9 #define Z_MIN_POS 0 #define X_MAX_POS 250 #define Y_MAX_POS 219 #define Z_MAX_POS 240 #define X_PROBE_OFFSET_FROM_EXTRUDER -42 // X offset: -left +right [of the nozzle] #define Y_PROBE_OFFSET_FROM_EXTRUDER -10 // Y offset: -front +behind [the nozzle] #define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle] // Set the boundaries for probing (where the probe can reach). #define LEFT_PROBE_BED_POSITION 10 #define RIGHT_PROBE_BED_POSITION 205 #define FRONT_PROBE_BED_POSITION 10 #define BACK_PROBE_BED_POSITION 205