Anet A8 Electronics Enclosure w/ Ramps (mosfets. Relay, RPI etc)

thingiverse

*****12/22/18 - There are some issues with the stl file. There is also an issue with the height of the case. For ramps if you are using dupont connectors your not going to be able to get the lid on. I am working on this. I am also trying to get a workable print as well to make sure it's viable. I am hoping to have a final STL by after the holiday. ***** I fixed 2 issues with the print but have not tested it. 1. Fixed the placement of RAMPS. It fit, but with the LCD adapter, it didn't. I should fit now. I built in support in the way of a knock out plate for usb. So you don't need to remove it. This will allow the print to print correctly and you can remove it with a sharp exacto blade. The one for the pi sd card is made to be cut out regardless. Stand by. I Had a need. I was going to design something like the one I remixed this from, but since this existed, I just had to edit it. Wanted to fit the stuff I used. It is designed to fit Ramps 1.4, Raspberry Pi for octoprint, 2 MOSFET's, buck converter and relay board for power and RGB control. I added an edited top section that has a mount for a small buck converter.