Anet A8 LCD Back Plate

thingiverse

The back plate that comes with the Anet A8 is poorly designed as it doesn't take into consideration some solder joints on the back of the board. This design leaves gaps where the solder joints are so that when it gets tightened it's not putting unnecessary pressure on the board. Could probably be improved quite easily, however this was good enough for me for now. Only downside is it leaves the solder joints exposed, however considering the over all design of the A8, this is probably not a huge concern. The STL differs slightly to the one in the picture, I've taken 5mm off each edge to make the whole thing a bit smaller.