Anet A8 LED Strip and camera mount

thingiverse

Use to light up your heatbed from the front side since i have the camera up front can also be use to mount on the back frame too just be careful with heatbed cables, it even fits behind the little space between stepper motor and the back frame for flexible placement. Camera mount for a Clip-on type webcam camera with thickness clamp of 1.5cm, i am using a cheap generic webcam. Few holes for cable routing on LED Holder. Note: Depending on how hot your led strips are, you may need ABS for the LED Strip mount. I printed mine in PLA it is fine and rather soft after a long period of time but it keeps its shape or you could use a thick double tape foam to insulate the heat instead of using the pre-mounted double sided tape that came with your led strips. This is a modular system so i can just replace the mount to fit different camera mount in the future. Print Settings Printer: Anet A8 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 0.2 Infill: 15 Notes: Mount and brace is strong enough with 15% infill, 2 shells and 2 bottom/top layers increase as needed if you need it stronger. 20% infill should be more than enough. Support is not needed since it is designed to be printed easily without it. I Printed mine @ 60mm/s.