ANET A8 Limit switch and chain mount

thingiverse

This is a mashup of Starwhopper and flyingferret prints. I added the Z Endstop Adjuster and the linear chain to extruder together for convenience and improved accessibility. The linear chain mount was moved back to allow straight access to the screw that adjusts the Z height. Also, It was raised by 1/2" because it always seemed too low, compared to the extruder mounting position. And.. I gave it a little extra to match another mod that I have yet to upload. The nut hole in the Z-endstop adjuster is super tight for a 3mm nut. You have you push it in very hard, then fish around for it with a 3mm screw. I made it this tight so you would not have to use lock nuts. The screw will not move on it's own. I added the Sketchup file so you can modify it as you want. I had to break the cross section to slip my wiring into it. I did not want to unplug everything. It did not seen to affect the grip on the chain at all. Print Settings Printer: Anet A8 Rafts: Doesn't Matter Supports: Yes Resolution: .2mm Infill: 20% Notes: Nope.