Anet A8 Plus Bed Glass frame with strain relief

thingiverse

UPDATE: just realized i had not uploaded the strain relief cover. to anyone who has downloaded i apologize and hope u was able to find the file in the link. ive added it now an also a squished model of the corner with the strain relief as a test so u can make sure its going to fit around properly. this will more than likely be down to how well you have you printer calibrated but ive printed it off printers with zero calibration an its worked so there shouldn't be any issues with this unless your printers is pretty bout out of calibration an if that is the case then this is the least of your worries but more than likely u've already addressed something like that if your looking for something like this. bed frame for the anet a8 plus with a strain relief integrated into the frame. this is the strain relief i integrated into the frame. https://www.thingiverse.com/thing:2482038 . i used a m4 nut to hold the frame in place an it helps with the spring moving around but its meant to hold the glass in place but i still use clamps just to be sure. ive only put one corner on as of now which was the one with the strain relief and it fits perfect on mine. i have the wire soldered to the bed but if u still have the connector it should still fit if not let me know where the issue is an i'll try to redesign it to fit. UPDATE: it fits fine, i had to solder the wires to my bed cause the plug broke off due to poor soldering an it actually pulled half of one of the pads off to the thermistor an it worked fine at first but after about a week the rest of the pad pulled loose even with the strain relief an it pretty much being clamped in place it still quit an after contacting anet they replaced the bed for me since it was a brand new printer. now I have a new bed on it with the connector and with the same frame it fit perfect. im also using 25mm long springs with m4x35 screws with the spring guides that lock into each other once compressed enough.