Anet a8 Spool Holder upgrade - For Sunlu spools

thingiverse

Hi Everyone, this is my design, thinked for holding the Sunlu spools. It works with the 608 bearings. The bearings holes are a bit larger, because you can leave the debris that are difficult to remove, when you cut the supports inside the recess, for allowing grip between the outside of the bearing and the inside of the recess. Yes, is for lazy people... (you need to print two identical part. You can't see it from the photos but there is one on each side. I wanted to clarify and not assume that it is clear) This is a WIP, so the advices are welcome. In the images you can see a oozing problem, that i have solved later, but it not depend from the model. I attach a step file i you want to reproduce it or customize. I've used 50% infil to make it stronger, but feel free to try lower or higher percentage. Edit: 25/03/2021 After falling at the ground, the object broke in directions of one of the 3 ray. (it was predictable) So i have added an edge fillet (7mm) as you can se in the v 1.8.