Anet E10 Z endstop adjuster / X switch holder

thingiverse

I designed MrCrankyface's Z endstop switch holder, then tried a handful of endstop adjusters. All were problematic for various reasons - they didn't line up with the Z endstop switch, the X switch was in the wrong place to contact the carriage, the bracket interfered with the X belt or zipties, and so on. So I iterated, eventually printing over 20 versions of my design. It uses M2 bolts (12-16mm) and nuts to hold the switch, will take a M3 hammer nut, and is designed for a M3 Z adjuster bolt. You will probably need to ream the adjuster hole a bit, which is what I prefer when "threading" a bolt directly against plastic. You can ream it for a M4 if you want. The design has a hollow cube to the side; this lets the extruder head alternate between printing the cube and printing the adjuster. When the extruder gets to the 'foot' of the adjuster, the tallest part while on the print bed, it has a tendency to overheat and turn the foot into a blob. This does a great job of preventing that. I designed it in Tinkercad, you can ungroup/move/regroup all of the parts if you need it to fit differently. https://www.tinkercad.com/things/5zKbBQwG8y1 Note CC-BY-NC; this is not to be used for (re)sale.