Anet e3d v6 63mm sn04 sensor mount

thingiverse

Here is a remix of the e3d v6 sn04 clamp by "moglubalu" made to fit an anet printer, plus additional m3 hex nut holders on the rear extruder facing side. This assumes you have a 63mm e3d v6 extruder on your anet a8 and plan to run auto leveling using skynet and the standard anet sn04 sensor. The particular carriage I'm using is from https://www.thingiverse.com/thing:2099577 by "TNS". However, I've modified it to be used without the turbine fan holder and instead use a 40mm fan mounted to the front of the 30mm. EDIT: December 10, 2017 Configuration H settings must be changed as follows: Maximum travel limit = 250 (be careful not to exceed too far from bed) Front_probe_bed_position = 0 Right_probe_bed_position = 205 (ignore probe position settings if using right side mount) Y_probe_offset = 0 Z_probe_offset = 0 X_probe_offset = -33 for left side or 33 for right side