Angled CO2 Laser Controller Housing w/ Removable Rear Door

thingiverse

This is my take on creating an angled housing for my Omtech AF2028 60W laser. It was designed to accommodate my KT332N Controller face. I do not know if it will work with other controllers. However, the front facing opening is 5.500" W x 4.125" H and the entire housing is 7.500" in width if that helps. The opening is slightly offset to the left to allow for plugging in the cable. Not sure how remixing works, but if anyone wants a shot at a remix, let me know. One note in reference to supports. The angle is at 45° so make sure your support criteria is correct. Mine was set at 50°. When it came to the top of the face's opening, the printer had to bridge that part. It did it successfully, but just wanted to make note of it as you may need to add supports in that area if your printer cannot create the bridge without supports. Mounting hardware used: (4) 10-24 x 3/4" machine screws w/ wingnuts (2) 5mm x 20mm Hex head bolts (These are for the little metal hold down brackets on the inside. The stock ones I had were too long and would not allow the installation of the rear door)