Angled Vertical Charging Stand - Pebble Time

thingiverse

As requested by Reddit, this version has an upper plate at 30deg to the base. I don't plan on printing this myself as I prefer the non-angled version, so I can't say if this will work or if the magnets on the Pebble charger are strong enough to hold the watch in place. Fairly straight forward vertical stand for the Pebble Time, designed to allow the straps to hang downwards instead of requiring you to feed them through gaps as required in other designs. The charging cable is secured into the printed part with a small strip of 3M 03609 VHB tape. The wire easily pushes into the groove, and is also held in place with a few strips of the same VHB. I strongly recommend you pick a place for the stand and affix it there with some Command Adhesive strips between the bottom of the stand and the surface top; the weight of the stand is not sufficient to allow you to just pull the watch off. Recommend printing with 0.2mm layer heights at 40 mm/s, 50% infill for structural rigidity. Support needed on the wire channel.