Anker PowerCore 10000 PD Battery Holder for Oculus Quest

thingiverse

This remix was made to accommodate this [Anker Powercore 10000 PD Charger](https://www.amazon.com/Anker-PowerCore-10000mAh-Portable-Delivery/dp/B07HBTY3Z2/). This battery has a slightly off center of gravity so if you slide the battery pack in towards the power button but stop there it should be slightly off center and will be balanced properly. Pictures show a rough draft (.3) print but I have since printed at .2 with 50% fill which took about 2 and a half hours to print on my Anycubic I3 Mega. To see better pics of this style battery clip on the Quest look at the [Belllsy's original design page](https://www.thingiverse.com/thing:3650180). The clip that goes on the Quest is very tight but you can sand it down. UPDATE: I have uploaded a new option that provides a looser fit so its not so hard to slide onto the Quest headband. I recommend this over the original one, but if its too loose you can go back to the original. 6/23/2019: I have uploaded a new version that goes all the way around the battery (Full Grip). I found that over time my PLA grip loosened with the original design. This version has remained tight for the battery and has the grip on the Quest strap that goers on easily. I would print this one if you are making this.