Another stand for the Gear Heart (hi-res, smoother)

thingiverse

This is a simple remix of MaikaiGuy's gear heart stand with the number of faces increased to produce smoother curves (as smooth as I could get it in OpenSCAD). Instructions This prints great with Slic3r's "spiral vase" setting; no seams! By turning the perimeter speed to max on my printer and adjusting the minimum time per layer ("Slow down if layer print time is below" in Slic3r's "Filament Settings"), using a minimum time of 3 sec & .2 layer height I was able to print this in under 9 minutes; any faster and the print would fail.