Antec - LANBoy Air - PC Case Feet

thingiverse

The tiny rubber feet that came on my Antec LANBoy AIr PC case were too short to allow good/proper airflow to the bottom of the case where the PSU intake is so I designed these feet to match the Antec LBA case styling. At approx 40mm height, these feet offer ample height while on a carpeted floor as to not prevent good airflow to the PSU inlet on the bottom of the case. Also worth noting that I eliminated the 2 middle feet that came with the Antec LBA since the 4 replacements offer much more surface contact area. I will be publishing a couple revisions in the near future...the 1st revision will reduce the amount of material required to print these feet and still remain sturdy/robust and the second revision will add SD card slots to the front feet for easy/convenient storage and access to you most used SD cards. note: I just remembered that I wanted to add a recess on the bottom to allow adding a rubberized disk to add traction for use on hard/smooth surfaces.