Antweight Horizontal Bar Spinner - Tiger Shark V2

thingiverse

This is version 2 of the frame and the first foray into 3D printing. You will notice in the video that the weapon is on the top instead of the bottom. It turned out I didn't have wheels large enough to make the robot sit level with the ground. The blade would touch the ground because it was so long. The compromise was to move the weapon to the top which worked out to some extent ###Weapon System [Weapon motor](https://www.fingertechrobotics.com/proddetail.php?prod=D282217) I believe at the time I may have had a bigger motor in the robot A2212 [Blade Hub](https://www.fingertechrobotics.com/proddetail.php?prod=ft-blade-hub) The weapon blade during this event was an 8x2 inch piece of aluminum that can be purchased from any hardware store. ###Drive Assembly [Drive Motor - Fingertech Spark](https://www.fingertechrobotics.com/proddetail.php?prod=ft-Sspark16) [Snap hubs - 0.75" wide](https://www.fingertechrobotics.com/proddetail.php?prod=ft-snap-hubs) [3 inch foam wheels](https://www.fingertechrobotics.com/proddetail.php?prod=ft-snap-wheels) https://youtu.be/8hFGeVeIb_0 https://youtu.be/gdHC0fycUas