Anycubic Chiron Cable Chain Z-Axis

thingiverse

Hi Guys, This is my third remix/design for the Anycubic Chiron. I wanted to create something so that the extruder cable and the Z axis would no longer be next to the printer. Because I turned my spool holder 90 ° towards the front (Check out my other Design) of the printer, I chose to install this cable chain towards the back of the printer. In total you need 28 times the "SHACKLE" and 30 times the "LID" I printed the lid at a Horizontal Expansion of -0,15 to -0,2 but you should try for yourself what works best for you. I placed the sixth link from the top backwards, so that the cable that goes to the extruder can be placed underneath the Z-axis motor. I did this because it is a bit shorter and if you feed it along the top, the printer cannot reach its maximum height I hope you like my design and if you use it I would like it if you leave a message, after all it is always nice when you are appreciated.