Anycubic i3 MEGA Dual Mosfet & Fan Mount

thingiverse

Modified from (http://www.thingiverse.com/thing:3333652 by Piotruchawro) Printed in ABS, Temps 240/80, In Fill 25%, Layer Height 0.2mm, Shell Thickness 0.8mm, Modified the Design to cater for Zip Ties to retain the various wires, the Lower Tangs on both Mounts are to retain the mounts in place under the Power Supply, I also altered the position where the Mosfet's Mount to allow for a Dual FAN Mount to sit in front of this Mosfet Mount.. Using all Original Mount points and Screws, used original MB Fan plus an extra. Can still refit the Base Cover if you wish to, though I do not feel it is necessary. I did have to extend one of the Mosfet connections to the Mainboard, you can see the joiner near the middle of the two fans, though this will depend on the Mosfet's you choose to use.