Anycubic i3 Mega Fan Duct for V6 Hot End

thingiverse

This is an updated fan duct for the anycubic i3 mega needed if you upgrade your stock v5 hotend to e3d v6 or compatible. It is very similar to the original but shorter to fit the smaller size of the v6. Notes: - It can be printed without supports - Can be improved, but it is a very good starting point 12-09-17: Updated to get a better height 22-09-17: Even better height, more focused hole and thicker layer to get easy prints. 29-09-17: Last version, with a little funnel and better placed screws support. Print this version rotated 90º over Y axis to get best results. 04-10-17: One version more. I noticed the piece was too wide, so some air were lost. I have increased the roof of the duct to improve focusing and the hole is more similar to the original one. Choose the one that best suits you! (I suggest you to use the last one)