Anycubic i3 Mega housing for 12864 LCD Graphic Smart Display Controller Board

prusaprinters

<p>This is a housing which can be used to mount a "12864 LCD Graphic Smart Display Controller Board" to an Anycubic i3 Mega.</p> <p><strong>BOM:</strong></p> <ul> <li>4x M3 5mm screw, 4x M3 washer (to mount the holders)</li> <li>4x M3 10mm screw (to mount the screen)</li> <li>2x M4 12mm screw, 2x M4 washer, 2x M4 nut (to mount the housing to the holders)</li> </ul> <p>I won't provide an adjusted firmware to make this display operational with an Anycubic i3 Mega/S!</p> <h3>Print instructions</h3><h3>Print Settings</h3> <p><strong>Infill:</strong> 20%<br/> <strong>Support:</strong> no<br/> <strong>Perimeters:</strong> 6<br/> <strong>Extrusion width:</strong> 0.45<br/> <strong>Layer height:</strong> 0.2, 1mm top/bottom thickness<br/> <strong>Filament:</strong> PETG, ASA, ABS</p> <h3>Post-Printing</h3> <p><strong>Rework the 4mm holes of the holders</strong><br/> To make the holes printable without using any supports, I closed them with a 0.2mm thin layer. Just use a screwdriver/knife or a 4mm drill to open them entirely again.</p>