Anycubic Kobra Max Print Head Cable Bracket

thingiverse

I designed this bracket to replace the P-Clip that is provided by anycubic to hold the print head cable near the extruder. It never made sense to me that they wanted the flat cable folded over and crammed into that little clip. This bracket uses the original screw for the P-Clip and creates a flat plate for the cable to sit on its side in and provides some support for the cable which likes to droop if not tied to the bowden tube. Version 2 rounds the edges a little bit to make them not so sharp and shifts the plate about 4mm to one side