Anycubic Kossel Linear Plus Top Mount Spool Holder - with 608zz Bearing

thingiverse

Hope you consider donating if you found this useful! Thanks! https://www.paypal.com/paypalme/jensterJ97 This is a top mount spool holder for the Anycubic Kossel Linear Plus (AKLP) delta printer that I have designed which uses a 608zz bearing. As the design is rather straight forward, the spool holder can be used in most delta printer with the same sized frame as the AKLP, 380mm*680mm. Assembly 1. To mount each bracket to the top of the frame (Bracket_x3), use 3 M4*8mm socket cap bolts and 3 M4 hammer T-nuts. 2. Position each of the bracket in the middle of the 2020 aluminium profile and tighten them. 3. Sit the spoolPlate on top of the brackets, then use 3 M4*10mm button head bolts, M4 washers and nuts to fasten it to the brackets. 4. Press fit the 608zz bearing into the spoolHub, then mount the assembly onto the center post of the spoolPlate. 5. Place your filament spool onto the spoolHub and you're good to go! *If you find trouble fitting the bearing into the spoolHub, you can throw the bearing into the freezer for about 10 minutes first and try press fitting again. It worked with mine. If this still doesnt, you could try some slight sanding or just modify the SOLIDWORKS part file that is included* BoM 1. M4*8mm x9 - Socket Cap Bolts 2. M4 washers x12 3. M4 Hammer T-nuts x9 4. M4*10mm x3 - Button Head Bolts 5. M4 Nuts x3 6. 608zz bearing x1