Anycubic Kossel PIP Cable Chain Mount

thingiverse

I loved eth4ck1e's PIP chain for the Chiron, and scrhall's Harness and Filament Strain Relief was another godsend, so I wanted to combine the two. Enter the PIP kit for the Anycubic Kossel. The only bit I remixed was the actual receptacle for the PIP chain where the wire guide was. The strain relief is still there (I'm missing some M3 hardware, hence why you don't see it in the pics), so it's really the best of both worlds. I also modified the male mount for the PIP chain in the 2020 extrusion. I used the standard version, however you may need to use the longer, or the more offset one, depending on your needs. I printed all parts on glass with perfect adhesion (use Babystep Z to achieve this on Marlin 1.1.9), and used Anycubic's own PLA for the Kossel, and PLA Pro for the Chiron. I suggest using PLA Pro, although AC's own PLA is very similar. Print settings are below. Print with no supports, given that your bridging settings are up to par. You will need to print at least two links in TPU in order to allow for flexible left/right movement. Some notes for the hardware: Use 2x M4 screws, M4x10-12 or so. Use 2x M4 tee-nuts. Current issues: The PIP receptacle is fragile due to design, so be careful Mounting of the lower male section needs to happen at the lowest 2020 extrustion Update 12/10/19: Fixed a mesh error in the chain mount Update 12/15/19 Uploaded a new version of the chain mount, with a rear mounted wire feed for a sideways V6 hot block mount. Update 12/16/19 Added the female version of the clip (totally forgot about it - my bad), and fixed an artifact in the nut slot (heh). Update 12/25/19 Merry Christmas! New pic added, along with a new collection of parts that make up for my current effector setup, which can be found here: https://www.thingiverse.com/thing:4068122