Anycubic Mega S Direct drive

cults3d

Direct drive assembly for Titan extruder using the stock Anycubic carriage plate, E3D V5 hot end . You can use E3D V6 too, just think to set the Z offset (if you used the E3D V5 before) ;) It designed to have the same size than the original to have nothing to modify in your configuration (software, hardware) and to avoid direct air flow on ABS prints ABS, PETG or similar are highly recommended to resist to the high temp of the hotend You'll need belt holder, rear fan duct you can get them here: https://www.thingiverse.com/thing:3710090 waiting I design them specially for this assembly parts list: 4x M3x12 raised head screw for the top 4x M3x (hotend fan thickness)+3mm 1x M3x12 +lock nut (it is mounted on the top right hole of carriage plate, from front to the back, due to the motor and base plate thicknness) Notes: When printing the top , put level Z at -5 to avoid default of the tiny parts at the bottom and if you have it, select adaptive layer, it gives great result (Cura settings are in the last pic) I use a 2.5mm drill and m3x0.4 middle taper Use holders everywhere for the base Use bed holders for the "couvercle"