Anycubic Mono X Drip Hanger

thingiverse

This remix include: -prolonging the hanger to better support printing bed - it should stop rotating around the screw - it was 2 mm short in my printer -adding cut off so the screw lay flat on bed (earlier it was partially on hanger partially on bed) -adding cut off for better leveling screws accessibility - I had issue accessing them with flex bed even with other remix, -moving back a 13mm hanger, so prints would be more above the vat. This should reduce spill overs - this mod is only added not printed yet, because I already printed few of the prototype. I would suggest printing in 101% scale, because it's really tight fit. Also use higher infill because taking material in those places will make hanger weaker from original design, so test it strength after printing and maybe print it with 30 degrees rotation to assure higher layer adhesion, but this totally depends on your printer.