Anycubic Photon M3 Heater Kit

thingiverse

This is a spacer to allow for the addition of a heater and thermometer kit as found through the Anycubic Photon M3 facebook page. This is not Air tight. If you want to print it out and help me modify it to be a bit tighter I am happy to take the help. I ended up putting duct tape around it to somewhat seal it to the printer. This adds about an inch space, a cradle for the heater, pass through holes for the heater power cable and the thermometer cable. I am considering this a work in progress. Its good enough for me to use and frankly its good enough to use. Contact me for the tinkercad link if you wish to improve this. The thermometer clip is from another Photon heater project on thingiverse. I did not use it personally.